Solar Panel Mounting System For RCC Rooftop
This structure is suitable & compatible for any flat roof / surface, which can withstand additional weight of panels, ballasts & structure. It is non penetrative clamping method of base rail to the ballast using SS ballast clamp. Distance between base rails can be adjusted as per tilt of the structure required. Ballast is used a a dead load for the structure. Ballast is made up of concrete (4″ x 4″) & its length & weight can vary as per requirement of the structure. Ballast weight is always more than pressure acting upon the system to act as a counterweight to airborne of the system. Fencing poles can be used as ballast as it is readily available in the market. It will save installation time.
Properties
- EPDM foam sheet for maximum grip at base rail to ballast connection, which has excellent water/UV/high temperature resistance.
- Non penetrative ballast clamp for firm clamping of base rail to the ballast, which is easy & fast to install & easy for maintenance.
- Adjustable structure tilt varies from 7 degree to 15 degree.
- Lower shading distance due to landscape orientation of the solar panel.
- Low rise of panel results in less wind pressure acting on the panel surface.
- It can be installed in both South & East West orientation.
- Less concrete work at site due to readily availability of fence poles, which can be used as Ballast.
- Structure is suitable & compatible for any flat roof / surface, which can withstand additional weight of panels, ballasts & structure.
